Panasonic KX-T0141 Quick Installation Manual page 37

Mounting the KX-T0141/KX-TDA0142
WARNING
•
Make sure that the wall that the unit will be attached to is strong enough to support the unit
(approx. 310 g [11 oz]). If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment (screws, washers) included with the unit.
•
When this product is no longer in use, make sure to detach it from the wall.
CAUTION
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
•
Do not stretch or bend the cables. Also, do not allow anything to rest on the cables.
•
Use cables that are fire-resistant or fireproof.
•
The CS and the cables should never be placed near or over a radiator or other heat source.
•
Do not bundle cables that are connected to the CS with the AC power cords of machines located
nearby.
•
Make sure the cables are securely fastened to the wall.
1.
Place the reference for wall mounting (KX-T0141/KX-TDA0142) on the wall to mark the 2 screw positions.
2.
Install the 2 screws and washers (included) into the wall.
Note
•
Make sure that the screw heads are at the same distance from the wall.
•
Install the screws perpendicular to the wall.
3.
Hook the CS on the screw heads.
Document Version 2009-12
Washer
Drive the screw
to this point.
8 Wall Mounting
Quick Installation Guide 37