Desa GMC7CF Assembly Instructions Manual page 25

Shutoff Valve
Propane/LP
Supply Tank
Gas Control Valve
Figure 25- Checking Gas Joints
(Propane/I9
Only)
INSTALLATION
OPTIONAL WIRELESS HAND-HELD
Continued
EMLICITC relltil"Call A
rreocnolcc
Equipment
Shutoff Val
• —an. • .-••-••• • • .....
(GHRCB Series & GHRCTB Series)
Installing Receiver
I.
Remove screws.
2. Disconnect switch wires from the control valve.
3. Remove switch plate (see Figure 27). Discard
switch plate after removing. Save the screws.
4. Locate the battery clip mounted on the back
of the receiver (sec Figure 28).
5. Slide 9-volt battery (not included) through
the clip.
6. Attach the terminal wires to the battery (see
Figure 28).
7. Connect wires as
shown
in Figure 30. page 20.
S. Install remote receiver unit onto fireplace base
using the two screws removed in step
one (see
Figure 29. page 20h
Switch
Gas
Screw
Plate
Red Wire
Gas Control
Valve
Figure 26- Checking Gas Joints
(Natural Gas Only)
Pressure Testing Fireplace Gas
Connections
I. Open equipment shutoff valve (see Figure 24,
page IS).
2. Open main gas valve located on or near gas
meter
for natural gas or open propane/LP sup-
ply tank valve.
3. Make sure control knob of fireplace is in the
OFF position.
4. Check all joints from equipment shutoff valve
to gas control valve (see Figures 25 or 26).
Apply noncorrosive leak
detection fluid to
all
joints. Bubbles conning show a leak.
5. Correct all leaks at once.
6. Light fireplace
(see Operating
Fireplace.
pages 22 through 25). Check all other inter-
nal joints for leaks.
7. Turn off fireplace (see
Ta ?urn Off Gas la
Appliance,
page 23).
Black'
Wire
-
Figure 27- Switch Plate and Wiring
Harness
Terminal
Battery Clip
9-Volt Battery
Figure 28- Attaching Battery to Receiver
113110
-
018
www.desatech.com
19