Dell PowerVault 775N Installation And Troubleshooting Manual page 94

them and clears any password(s) currently in use.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the cover (see
3. Remove the jumper plug from the password jumper.
See Figure A-2 to locate of the password jumper (labeled "PASSWD") on the system board.
4. Replace the cover (see
5. Reconnect your system and peripherals to their electrical outlets, and turn on the system.
The existing passwords are not disabled (erased) until the system boots with the password jumper plug removed.
However, before you assign a new system and/or setup password, you must install the jumper plug.
NOTE: If you assign a new system and/or setup password with the jumper plug still removed, the system
disables the new password(s) the next time it boots.
6. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
7. Remove the cover (see
8. Install the jumper plug on the password jumper.
9. Replace the cover (see
10. Reconnect your system and peripherals to their electrical outlets, and turn on the system.
11. Assign a new system and/or setup password.
To assign a new passwords using the System Setup program, see "Assigning a System Password" in the User's Guide.
Back to Contents Page
"Removing the Cover" in "Troubleshooting Your System").
"Replacing the Cover" in "Troubleshooting Your System").
"Removing the Cover" in "Troubleshooting Your System").
"Replacing the Cover" in "Troubleshooting Your System").