Troubleshooting The Diskette Drive - Dell PowerVault 775N Installation And Troubleshooting Manual

Network attached storage servers
Hide thumbs Also See for PowerVault 775N:
Table of Contents

Advertisement

1. Turn on the system, including any attached peripherals.
If no error messages appear, go to step 15.
2. Enter the System Setup program to check the system memory setting (see "Using the System Setup Program," in the
User's Guide for instructions).
3. If the amount of memory matches the system memory setting, go to step 15. Otherwise, continue to step 4.
4. Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.
5. Remove the cover (see
CAUTION:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
6. Reseat the memory modules in their connectors (see
7. Replace the cover (see
8. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
9. Enter the System Setup program and check the system memory again.
If the amount of memory matches the system memory setting, go to step 15. Otherwise, perform the following steps:
a. Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.
b. Remove the cover (see
NOTE:
There are multiple configurations for the memory modules; see
in "Installing System Options." The following steps are an example of one configuration.
10. Swap the memory module pair in bank 1 with another pair of the same capacity.
11. Replace the cover (see
12. Reconnect your system and peripherals to their electrical outlets, and turn on the system.
13. As the system boots, observe the monitor screen and the indicators on the keyboard.
14. Perform the following steps:
a. Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet.
b. Remove the cover (see
c. Repeat steps 10 through 13 for each memory module pair installed.
If the problem is not resolved, see
15. Run the system memory test in system diagnostics.
If the test does not complete successfully, see

Troubleshooting the Diskette Drive

Problem
"Removing the
Cover").
"Replacing the
Cover").
"Removing the
Cover").
"Replacing the
Cover").
"Removing the
Cover").
"Getting
Help."
"Getting
"Installing Memory
Modules" in "Installing System Options").
"Memory Module Installation
Help."
Guidelines"

Advertisement

Table of Contents
loading

Table of Contents