Installing Memory Modules - Dell PowerVault 775N Installation And Troubleshooting Manual

steps 1 through 6, ensuring that the memory modules are firmly seated in their connectors.
8. Run the system memory test in system diagnostics.

Installing Memory Modules

CAUTION: Before you perform this procedure, you must turn off the system and disconnect it from its
power source. For more information, see
Your System."
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the cover (see
3. Locate the memory module connectors in which you will install a memory module (see
4. Press down and outward on the memory module connector ejectors, as shown in
module to be inserted into the connector.
Figure 6-5. Removing and Installing a Memory Module
5. Align the memory module's edge connector with the alignment key, and insert the memory module in the connector
(see Figure 6-5).
The memory module connector has an alignment key that allows the memory module to be installed in the connector in
only one way.
6. Press down on the memory module with your thumbs while pulling up on the ejectors with your index fingers to lock
the memory module into the connector (see
When the memory module is properly seated in the connector, the memory module connector ejectors should align with
the ejectors on the other connectors with memory modules installed.
7. Repeat steps 3 through 6 of this procedure to install the remaining memory modules.
8. Perform steps 4 through 8 of the procedure in
"Safety First—For You and Your System
"Removing the Cover" in "Troubleshooting Your System").
Figure
"Performing a Memory
6-5).
Upgrade."
" in "Troubleshooting
Figure A-3).
Figure 6-5, to allow the memory