Installing The Switch On A Wall; Attaching The Brackets To The Switch - Cisco Catalyst 2950 Hardware Installation Manual

Chapter 3 Installation

Installing the Switch on a Wall

Warning
Warning

Attaching the Brackets to the Switch

78-11157-05
To comply with safety regulations, mount switches on a wall with the front
panel facing up.
If a redundant power system (RPS) is not connected to the switch, install an RPS
connector cover on the back of the switch.
You can mount the Catalyst 2950 switch to a wall in a face-up configuration. To
attach the switch to a wall, follow the procedures in this section.
1. Attaching the Brackets to the Switch, page 3-23
Attaching the RPS Connector Cover, page 3-24
2.
Mounting the Switch to a Wall, page 3-25
3.
Use the supplied Phillips flat-head screws to attach a bracket to the switch.
Figure 3-18 shows how to attach the bracket to one side of the switch. Follow the
same steps to attach the second bracket to the opposite side of the switch.
Catalyst 2950 Desktop Switch Hardware Installation Guide

Installing the Switch on a Wall

3-23