Leds - Cisco Catalyst 2950 Hardware Installation Manual

Chapter 2 Overview

LEDs

Figure 2-13 LEDs on Catalyst 2950-12, 2950-24, 2950C-24, 2950SX-24, and 2950T-24 Switches
System
LED
S Y S T
Port mode
S T A T
LEDs
U T IL
Mode button
78-11157-05
You can use the LEDs to monitor switch activity and performance. The locations
of the LEDs vary among switch models. The Mode button that you use to select
the port mode also varies by model. See these figures:
Figure 2-13 for the Catalyst 2950-12, 2950-24, 2950C-24, 2950SX-24, and
•
2950T-24 switches
Figure 2-14 for the Catalyst 2950G-12-EI, 2950G-24-EI, and
•
2950G-24-EI-DC switches
Figure 2-15 for the Catalyst 2950G-48-EI switches
•
Figure 2-16 for the Catalyst 2950ST-8 LRE and 2950ST-24 LRE switches
•
• Figure 2-16 for the Catalyst 2950ST-24 LRE 997 switches
All of the LEDs described in this section (except the utilization meter [UTIL]) are
visible in the Cluster Management Suite (CMS). The switch software
configuration guide describes how to use CMS to configure and to monitor
individual switches and switch clusters.
RPS
LED
1 x
R P S
D U P L X
S P E E D
M O D E
Port status
LEDs
2 x
3 x
4 x
Catalyst 2950 Desktop Switch Hardware Installation Guide
Front-Panel Description
5 x
6 x
2-17