Table of Contents
Advertisement
Figure 49 : VGA monitor position screen
You can save your Display settings by highlighting "Save" and pressing the
exits the screen without saving the changes.
Recording Setup
Your recorder offers a variety of flexible recording modes. You can set it up to record all the time or to only
record events. It can be set up to continue recording once the hard disk drive is full by recording over the
oldest video, or you can set it up to alert you when the hard disk is full and stop recording.
Record
Highlight "Record" in the Record menu and press the
Figure 51 : Record - Settings screen
Highlighting "De-Interlace" and pressing the
recorder will turn the de-interlace filter on while recording video with Very High (D1) resolution.
Note: The video signal has a time difference of 1/50 second between odd and even fields
because it is composed of 50 interlaced fields per second. When recording video with
Very High (D1) resolution, video is made up of frame units combining two fields – one odd
field and one even field. This can cause horizontal scan lines or flashes in areas with motion
because of the time difference between the two fields. Turning on the de-interlace filter
provides clearer video by eliminating these horizontal scan lines and flashes.
The recorder can record up to four audio inputs. Highlighting "Record Audio" and pressing the
toggles between On and Off.
Use the arrow buttons on the setup screen to move the VGA screen
position in the direction you want. Selecting the
center returns to the previous position.
Figure 50 : Record menu
button. The "Record" setup screen appears.
Highlighting "Overwrite" and pressing the
toggles between On and Off. In the Overwrite mode,
the recorder records over the oldest video data once all
available storage space has been used. When
Overwrite is turned off, the recorder stops recording
once all available storage space has been used.
Highlight the "Event Record Dwell" box and set the
length of time you would like to record for the
associated event. You can set the dwell from 5
seconds to 30 minutes (Simple Mode only). Refer to
Event Actions screen in this chapter for information
regarding event recording.
button toggles between On and Off. When set to On, the
button at the
button. Selecting "Cancel"
button
button
37
Advertisement
Table of Contents
