Paint Section And Call Button - Sony RCP-TX7 Operating Instructions Manual

Location and Function of Parts

3 Paint section and CALL button

!™ Shutter setting block
!¡ DETAIL knob
0 MASTER GAMMA knob
9 Master black adjustment
block
8 CALL button
7 IRIS/M.BLACK LINK button
1 Master gain setting block
Includes the buttons, a display window, and a DPR
indicator described below.
The setting that can be performed via this block differ
according to the connected camera.
When using a DXC-D30/D30P: Select the gain
value from –3, 0, +3, +6, +9, +12, +18, +24 dB,
and HYPER GAIN. (HYPER GAIN equals 30 dB
+ DPR, but the DPR indicator will not light if it is
selected.)
When using a DXC-637 series camera: Select the
gain level from LOW, MID and HIGH. The gain
value corresponding to each value is set by
camera.
8
C.SCAN DPR
ON/OFF SHUTTER MASTER GAIN
AUTO
MASTER
DETAIL KNEE
GAMMA
BLACK
AUTO AUTO PRESET MANUAL
MANUAL
FLARE
BLACK/FLARE
EXT
AUTO
MASTER BLACK IRIS
CALL
IRIS/M.BLACK
LINK
REMOTE CONTROL PANEL
Name
4 (up) button
$ (down) button Each press of this button lowers the
DPR button and
indicator
Display window Displays the current master gain value.
a)DPR (Dual Pixel Readout) function: When this function is
2 SKIN DETAIL button (only when using DXC-
D30/D30P)
Press to perform skin detail correction. (The button
will light when pressed.)
For details, see "Skin Detail Correction/Skin Matrix
Adjustment (for DXC-D30/D30P Only) "on page 25.
1 Master gain setting block
2 SKIN DETAIL button
SKIN
DETAIL
3 Knee correction block
4 White balance adjustment
WHITE
5 Black balance adjustment/
CLOSE OPEN
COARSE
6 Iris adjustment block
SENS
Operation
Each press of this button raises the
setting value by one step.
When using the DXC-D30/D30P, press
the up and down buttons simultaneously
to set the master gain to 0 dB.
setting value by one step.
When using the DXC-D30/D30P, press
the up and down buttons simultaneously
to set the master gain to 0 dB.
When the master gain is set at 18 or 24
dB, press this button to activate DPR
function a) .
active, CCD output signal readout is performed one pair
of two adjacent pixels after another instead of one pixel
after another. Sensitivity increases (but resolution
decreases) as signal readout take place at a time for the
two pixels in each pair.
block
flare correction block