Mercedes-Benz E-Class Coupe Operator's Manual page 71

Always pay particular attention to the traffic
situation and be ready to brake, especially if
®
PRE-SAFE Brake warns you. Terminate the
intervention in a non-critical driving situation.
In particular, the detection of obstacles can
be impaired if there is:
dirt on the sensors or anything else
R
covering the sensors
snow or heavy rain
R
interference by other radar sources
R
the possibility of strong radar reflections,
R
for example in parking garages
a narrow vehicle traveling in front, e.g. a
R
motorbike
a vehicle traveling in front on a different line
R
relative to the center of your vehicle
G
WARNING
®
PRE-SAFE Brake does not react:
to people or animals
R
to oncoming vehicles
R
to crossing traffic
R
when cornering
R
As a result, PRE-SAFE
give warnings nor intervene in all critical
situations. There is a risk of an accident.
Always pay careful attention to the traffic
situation and be ready to brake.
In order to maintain the appropriate distance
to the vehicle in front and thus prevent a
collision, you must apply the brakes yourself.
X
To activate/deactivate: activate or
deactivate PRE-SAFE
board computer ( Y
®
When PRE-SAFE Brake is activated, the
Ä symbol appears in the multifunction
display, as long as the HOLD function is
deactivated ( Y page 189). On vehicles with
the Active Parking Assist driving system,
the Ä symbol is displayed when position
P is engaged or you are driving faster than
22 mph (35 km/h).
®
Brake may neither
®
Brake in the on-
page 222).
Driving safety systems
®
For PRE-SAFE Brake to assist you when
driving, the radar sensor system must be
switched on ( Y page 226) and be
operational.
Following damage to the front end of the
vehicle, have the configuration and operation
of the radar sensors checked at a qualified
specialist workshop. This also applies to
collisions at low speeds where there is no
visible damage to the front of the vehicle.
i USA only: This device has been approved
by the FCC as a "Vehicular Radar System".
The radar sensor is intended for use in an
automotive radar system only. Removing,
altering or tampering with the device will
void any warranties, and is not permitted
by the FCC. Do not tamper with, alter, or
use the device in any non-approved way.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.
i Canada only: This device complies with
RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause interference,
and
2. this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Removal, tampering, or altering of the
device will void any warranties, and is not
permitted. Do not tamper with, alter, or use
the device in any non-approved way.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.
69
Z