TANDBERG 3000 MXP Profile User Manual page 21

Introduction
Remote Control
The remote control is used to control all functions of the system. The remote control uses 4 AAA
batteries. The system will tell you when batteries are running low. Change the batteries at the
back of the remote control. Please follow the guidelines on the packing material for handling and
disposal instructions for the batteries.
The reach of the remote control signal is 20 meters (65 feet). The remote control IR receiver is
located on the WAVE II camera. For users working in an open environment with multiple systems
deployed, this can cause other systems to respond to your remote control. Use the little white
switch placed under the batteries to change the reach of the signal from 20 meters (65 feet) to 2
meters (6.5 feet). This will prevent you from unintentionally controlling another video system when
you control your own system.
If the screen saver is activated (black or blank monitor), pick up the remote control and touch the
sides. This will automatically wake up the system.
Microphone
The high quality table microphone is designed to be placed on a table during a video meeting. Up
to three microphones can be connected. The ideal location for the microphone is on a flat surface
at least 2m (6.5 ft) from the front of the system. The microphone cable should always point
towards the system. The system will automatically equalize sound levels. Loud and soft voices
are picked up and transmitted to the far end at approximately the same level.
Table microphone
7