Table of Contents
Advertisement
In Case of Difficulty
You hear noise in the handset, and none of the keys or buttons work
•
Make sure the power cord is plugged in.
Common cure for electronic equipment
If the unit does not seem to be responding normally, then try putting the handset
in its base. If it does not seem to respond, do the following (in the order listed):
1.
Disconnect the power to the base.
2.
Disconnect the handset battery.
3.
Wait a few minutes.
4.
Connect power to the base.
5.
Reinstall the battery.
6.
Wait for the handset to re-establish its link with the base. To be safe, allow up
to one minute for this to take place.
Your answering system is not recording messages
•
Make sure system is turned ON (the ON/OFF key is illuminated).
•
Make sure Announce Only feature is set to OFF.
You cannot hear recorded messages
•
Using the base volume control, raise the volume to a comfortable listening
level.
CL is flashing in the base message window display
•
You need to set the day and time. Refer to the section on Set the Clock in this
user's manual.
2450a.pmd
34
34
12/29/2004, 8:44 AM
Advertisement
Chapters
Table of Contents
