Setting Up Your Answering System; Feature Summary - VTech t 2450 Manual

Answering System Operation

Setting Up Your Answering System

You can set up one feature at a time, or you can set up a feature and then move
on to set up another feature.
1. Make sure the answering system is ON.
2. Press MENU until the system announces the feature you want to set.
Refer to the Feature Summary below for a description of the features and
your choices.
3. Press CHANGE until the system announces the desired setting.
4. Press TIME/SET to confirm your selection.
5. Press MENU to move on to the next feature, or press a MAILBOX button to
exit Feature Setup.

Feature Summary

Default settings indicated by
System announces:
System announces: Description/directions:
"Set Security Code"
*
50
"Set Audible Message Alert " When message alert is turned on, the base beeps
*
Off
On
"Set Announce Only"
*
Off
On
"Set Base Ringer"
*
On
Off
"Set Number of Rings"
2
*
4
6
Toll Saver
NOTES:
1. To advance the remote access code by increments of 10, press and hold
CHANGE.
2. You can exit feature setup at any time by pressing a MAILBOX button.
2450a.pmd
*
.
Description/directions:
Use CHANGE to choose the remote access code
you will use to access features and functions of the
answering system from a touch tone phone. You can
select any two digit code, from 40 to 99.
once every 10 seconds when new messages
have been received.
When you turn Announce Only On, callers hear
your announcement, but cannot leave a message.
Turn the base ringer on or off.
Choose how many times the phone will ring
before the system answers a call.
With toll saver active, the system answers after two
rings when you have new messages and after
four rings when you have no new messages.
26
26 12/29/2004, 8:44 AM