Table of Contents
Advertisement
Manual Mode
Manual mode requires the user to turn the
heater on and off manually.
To Start
Press the "Manual Start" button. That's it. The
stove automatically goes to a medium burn rate
and high fan while the igniter starts the fire
burning within 10 minutes. During this period
the lowest "HEAT OUTPUT" light will flash. If
the stove does not start in 30 minutes, the
stove turns off.
Once up to temperature, the stove will then
run at the heat output setting selected on the
control panel (see "To Adjust the Heat" below).
To Shut Down
Move the mode switch to "OFF". The exhaust
blower will still run until the heater cools down.
To Adjust the Heat
Press the "Heat" buttons to adjust the heat
output.
NOTE: During start-up you may adjust the heat
setting. This heat setting will take affect once
the start-up sequence is complete.
© Travis Industries
Operation
H
E
A
T
F
A
N
H
E
A
T
F
A
N
TRAVIS INDUSTRIES
DISCONNECT POWER BEFORE SERVICE
H
E
A
T
O
U
T
P
U
T
H
E
A
T
F
A
N
4 0 8 0 7 2 3
AUTO
UP
OFF
MANUAL
MANUAL
DOWN
START
UP
MANUAL
DOWN
AUGER
TM
TRAVIS INDUSTRIES
HOUSE OF FIRE
AUTO
UP
OFF
MANUAL
MANUAL
DOWN
UP
START
MANUAL
DOWN
AUGER
TM
HOUSE OF FIRE
HIGH
AUTO
MANUAL
MED
AUGER
These lights
LOW
indicate the
MAINT.
heat output
(REQUIRED)
setting.
AUTO
UP
OFF
NOTE: the
MANUAL
lights may
be difficult to
see from an
MANUAL
DOWN
angle.
START
UP
MANUAL
DOWN
AUGER
TM
TRAVIS INDUSTRIES
HOUSE OF FIRE
1 9
Press the
"up" or
"down"
button to
adjust the
heat output.
1 0 0 - 0 1 1 4 5
Advertisement
Table of Contents
