Condensate Evaporation; Drain Plug; Drain Hole - Soleus Air PE7-10R-03 Operating Instructions Manual

CONDENSATE EVAPORATION

Emergency Condensate Holding Tank
When the room temperature is low and the indoor humidity is high, the air conditioner may not be able to
evaporate some of the moisture fast enough. When this happens, the water will accumulate in an emergency
condensate tank inside the unit. Once the emergency condensate tank is full, the unit will automatically shut
off and the FULL light will appear on the control panel display. To empty the condensate tank, unscrew the
screw plug at the bottom back of the unit. You will need a small pan, approximately 1" high to catch the water
coming out of the condensate tank. Once the condensate tank is drained, the unit will begin working within a
few minutes. The emergency condensate tank holds approximately 1.5 Liters of water. Another option is to
purchase a small hose from a hardware store that can fit around the 5/8" drain plug on the back of the unit and
drain the unit into a gravity drain or larger pan for continuous drainage.
To resume operation quickly, empty the water container according to the following steps:
1. Turn the unit off. Do not move the unit when the water container is full.
2. Place the drain pan accessory under the drainage port at the back of the unit.
3. Remove the drain plug from the drain hole. The condensate water will drain out automatically. When the
drain pan is full, place the drain plug back onto the drainage hole to stop the water flow. Empty the drain
pan. Repeat until all the water is emptied.
Once the water container has been emptied, place the drain plug back onto the drain hole. Do not
allow the water to drip continuously into the drain pan, as it might easily overflow.

DRAIN PLUG

DRAIN HOLE

11