Sundance Spas Camden Owner's Manual page 22

3. Turn On Power
Turn on power to spa at the home's circuit breaker to start boot up
sequence (sec. 9.0, page 23). The heater and filter/circulation pump
will automatically activate after several seconds. If the control panel
LED flashes water temperature and "COOL" or "ICE" this is normal.
Refer to page 39 for additional information.
4. Activate Jets Pumps
Turn on all jet(s) pumps to ensure proper mixing when
adding start-up chemical in step 5.
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your Sundance
dealer. See section titled "WATER QUALITY MAINTENANCE" (page
36) for general guidance.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading between 3.0-4.0 ppm Chlorine or
2.0-4.0 ppm Bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool And Spa Professionals/USA printed on the
inside cover of this manual. If sanitizer levels cannot be stabilized,
perform the decontamination procedure steps 9-15 on the following
page. Note: the "decontamination procedure" steps 9-15 should also
be used after the spa has been "Winterized" (sec. 11.8, page 34) or
has been sitting without power for an extended period.
7. Set Spa To Heat
To warm spa water to a comfortable temperature, follow
these steps:
• The LED display on the control panel displays the actual
temperature of the spa water. Press either the COOLER
(Down) or WARMER (Up) button once to display the "set" tempera-
ture for 5 seconds. If you want the water to heat to a different tem-
perature, simply press COOLER or WARMER within 5 seconds. The
set temperature increases or decreases by one degree each time
one of these buttons is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Page 16
2 2
1 1