Safety Message Alert Symbols - MULTIQUIP FCG1 SERIES Operations & Parts Manual

FCG1 CONCRETE SAW— SAFETY MESSAGE ALERT SYMBOLS
FOR YOUR SAFETY AND THE SAFETY OF OTHERS!
Safety precautions should be followed at all times when operating
this equipment. Failure to read and understand the Safety
Messages and Operating Instructions could result in injury to
yourself and others.
This Owner's Manual has been developed to provide
complete instructions for the safe and efficient operation
of the MQ Whiteman FCG1 CONCRETE SAW. For
engine maintenance information, please refer to the
engine manufacturers instructions for data relative to its
safe operation.
Before using this CONCRETE SAW, ensure that the
operating individual has read and understands all
instructions in this manual.

SAFETY MESSAGE ALERT SYMBOLS

The three (3) Safety Messages shown below will inform you
about potential hazards that could injure you or others. The
Safety Messages specifically address the level of exposure to
the operator, and are preceded by one of three words: DANGER,
WARNING, or CAUTION.
DANGER:
SERIOUSLY injured if you DO NOT follow
directions.
WARNING:
SERIOUSLY injured if you DO NOT follow
directions.
CAUTION:
DO NOT follow directions.
Potential hazards associated with FCG1 Concrete Saw operation
will be referenced with " Hazard Symbols " which appear
throughout this manual, and will be referenced in conjunction
with Safety " Message Alert Symbols ".
PAGE 6 — FCG1 CONCRETE SAW— OPERATION & PARTS MANUAL — REV. #1 (10/08/02)
NOTE
You WILL be KILLED or
You CAN be KILLED or
You CAN be injured if you
HAZARD SYMBOLS
Lethal Exhaust Gases
Engine exhaust gases contain poisonous
carbon monoxide. This gas is colorless and
odorless, and can cause death if inhaled.
NEVER operate this equipment in a confined
area or enclosed structure that does not
provide ample free flow air.
Explosive Fuel
Gasoline is extremely flammable, and its
vapors can cause an explosion if ignited. DO
NOT start the engine near spilled fuel or
combustible fluids. DO NOT fill the fuel tank
while the engine is running or hot. DO NOT
overfill tank, since spilled fuel could ignite if it
comes into contact with hot engine parts or
sparks from the ignition system. Store fuel in
approved containers, in well-ventilated areas
and away from sparks and flames. NEVER
use fuel as a cleaning agent.
Burn Hazards
Engine components can generate extreme heat.
To prevent burns, DO NOT touch these areas
while the engine is running or immediately after
operations. NEVER operate the engine with
heat shields or heat guards removed.
Rotating Parts
NEVER operate equipment with covers, or
guards removed. Keep fingers , hands , hair
and clothing away from all moving parts to
prevent injury.