Safety Message Alert Symbols - MULTIQUIP MP25E1 Operation Manual

FOR YOUR SAFETY AND THE SAFETY OF OTHERS!
Safety precautions should be followed at all times when
operating this equipment. Failure to read and understand
the Safety Messages and Operating Instructions could result
in injury to yourself and others.
NOTE
For engine maintenance information, please refer to the
engine manufacturers instructions for data relative to its safe
operation.
Before using this MASONRY SAW, ensure that the
operating individual has read and understands all
instructions in this manual.

SAFETY MESSAGE ALERT SYMBOLS

The three (3) Safety Messages shown below will inform you
about potential hazards that could injure you or others. The
Safety Messages specifically address the level of exposure
to the operator, and are preceded by one of three words:
DANGER, WARNING, or CAUTION.
DANGER
You WILL be KILLED or SERIOUSLY injured if you
DO NOT follow directions.
WARNING
You CAN be KILLED or SERIOUSLY injured if you DO
NOT follow directions.
CAUTION
You CAN be injured if you DO NOT follow directions.
PAGE 8 — MQ MP2 SERIES SAW — OPERATION MANUAL — REV. #0 (01/26/09)
SAFETY MESSAGE ALERT SYMBOLS
This Owner's Manual has
been developed to provide
complete instructions for the
safe and efficient operation of
the MP2 Saw.
HAZARD SYMBOLS
Potential hazards associated with operation of the pump will
be referenced with Hazard Symbols which appear throughout
this manual, and will be referenced in conjunction with Safety
Message Alert Symbols. Some examples are listed below:
WARNING - Guards and Covers In Place
NEVER operate the saw without blade
guards and covers in place. Adhere to
safety guidelines ANSI American
National Standards Institute, OSHA or
other applicable local regulations.
WARNING - Rotating Blade
Rotating blade can cut and crush.
Keep hands and feet clear.
WARNING - Burn Hazards
Engine components can generate
extreme heat. To prevent burns, DO
NOT touch these areas while the engine
is running or immediately after
operations. NEVER operate the engine
with heat shields or heat guards
removed.
WARNING - Rotating Parts
NEVER operate equipment with
covers, or guards removed. Keep
fingers, hands , hair and clothing
away from all moving parts to prevent
injury.