MULTIQUIP FCG1 SERIES Operations & Parts Manual page 26

Drive Belt
Refer to pages 17 to 18 of this manual for Drive Belt adjustment
procedures and Removal and Replacement procedures.
Engine
Follow the maintenance procedures outlined in the engine
owner's manual. Also refer to pages 22 to 24 of this manual.
Engine Oil Change
Drain the used oil while the engine is warm by the following:
Refer to Figure 22.
1. Place an oil pan or suitable container below the engine drain
plug to catch the used oil.
2. Remove the filler cap/dipstick and the drain plug.
3. Drain the oil completely and reinstall the drain plug. Ensure
the drain plug is tightened securely.
PAGE 26 — FCG1 CONCRETE SAW— OPERATION & PARTS MANUAL — REV. #1 (10/08/02)
FCG1 CONCRETE SAW — MAINTENANCE
NOTE
4. Make sure the engine is in a level position and fill to the outer
edge of the oil filler hole with the recommended oil. (See
Table 3.) Engine oil capacity is 0.63 US quart (0.60 liter).
CAUTION CAUTION CAUTION
CAUTION CAUTION
5. Screw in the filler cap/dipstick securely.
Figure 22. Engine Oil Change
Dispose of used oil properly. DO
NOT pour used oil on the ground,
down a drain, or throw in the trash.
Used oil can generally be taken to
your local recycling center or
service station for reclamation.
Running the engine with a low oil level can
cause engine damage.