MULTIQUIP FCG1 SERIES Operations & Parts Manual page 9

GENERAL SAFETY
■ ALWAYS read, understand, and follow procedures in
Operator's Manual before attempting to operate equipment.
■ ALWAYS be sure the operator is familiar with proper safety
precautions and operating techniques before using the saw.
■ NEVER leave the machine unattended while running.
■ Block the unit when leaving or when using on a slope.
■ ALWAYS check to make sure that the operating area is clear
before starting the engine.
■ Maintain this equipment in a safe operating condition at all
times.
■ ALWAYS stop the engine before servicing, adding fuel and
oil.
■ NEVER run the engine without the air filter. Severe engine
damage could occur.
■ ALWAYS service air cleaner frequently to prevent carburetor
malfunction.
■ AVOID wearing jewelry or loose fitting clothing that may snag
on the controls or moving parts, this can cause a serious
injury.
■ ALWAYS keep clear of rotating or moving parts while
operating or the saw.
■ ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of
the reach of children.
■ NEVER use accessories or attachments which are not
recommended by the manufacturer for this equipment.
Damage to the equipment and/or injury to user may result.
■ ALWAYS check to make sure that the
operating area is clear before starting the
engine.
■ Keep all inexperienced and unauthorized people away from
the equipment at all times.
FCG1 CONCRETE SAW — OPERATION & PARTS MANUAL — REV. #1 (10/08/02) — PAGE 9
FCG1 CONCRETE SAW— RULES FOR SAFE OPERATION
WARNING
DIAMOND BLADE SAFETY
■ Use appropriate steel centered diamond blades
manufactured for use on concrete saws.
■ Always inspect diamond blades before each use. The blade
should exhibit no cracks, dings, or flaws in the steel centered
core and/or rim. Center (arbor) hole must be undamaged
and true.
■ Examine blade flanges for damage, excessive wear and
cleanliness before mounting blade. Blade should fit snugly
on the shaft and against the inside/outside blade flanges.
■ Ensure the blade is marked with an operating speed greater
than the blade shaft speed of the saw.
■ Only cut the material that is specified by the diamond blade.
Read the specifications of the diamond blade to ensure the
proper tool has been matched to the material being cut.
■ Always keep blade guards in place. Exposure of the diamond
blade must not exceed 180 degrees.
■ Ensure that the diamond blade does not come into contact
with the ground or surface during transportation. DO NOT
drop the diamond blade on ground or surface.
■ The engine governor is designed to permit maximum engine
speed in a no-load condition. Speeds that exceed this limit
may cause the diamond blade to exceed the maximum safe
allowable speed.
■ Ensure that the blade is mounted for proper operating
direction.
SAW TRANSPORTATION SAFETY
■ Use the lifting handle and/or the appropriate lifting equipment
to ensure the safe movement of the saw.
■ DO NOT use the handle bars and/or front pointer as lifting
points.
■ NEVER attempt to tow the untrailered saw behind a vehicle.
■ Do not use on slopes or on extremely unlevel surfaces. An
engine tipped to extreme angles may cause oil to gravitate
into the cylinder head making the engine difficult to start.
■ NEVER transport the saw with the blade mounted.