Introduction; Figure 1-1. Typical Powerware 9315 Ups System; Chapter 1 Introduction - Eaton Powerware 9315 Installation Manual

Chapter 1
This manual describes how to install your Powerware
(UPS) system. It contains instructions for installing the UPS and each optional component
and accessory. The information you will use depends on the system you purchased.
Each component of your UPS system is housed in a free-standing cabinet. The cabinets line
up and match in style and color, and have safety shields behind the doors for hazardous
voltage protection. Figure 1-1 shows a typical UPS system that includes at least one of each
component.
These basic UPS system configurations are possible:
A
A
A
A
A
A
You can enhance any of these system configurations by adding optional accessories such as
a Remote Monitor Panel (RMP), Relay Interface Module (RIM), Supervisory Contact Module
(SCM), or Remote Emergency Power−Off (EPO) control.
9315 UPS (300–500 kVA) Installation Manual S 164201118 Rev H www.powerware.com
EATON Powerware
®

Introduction

UPS
Cabinet
(optional)

Figure 1-1. Typical Powerware 9315 UPS System

The UPS and one or more battery cabinets
The UPS, battery cabinet(s), and a Power Distribution Module (PDM)
The UPS, battery cabinet(s), and an input cabinet (transformer or filter)
The UPS, battery cabinet(s), PDM, and an input cabinet (transformer or filter)
The UPS, battery cabinet(s), an input cabinet (transformer or filter) and an output
transformer cabinet
The UPS, battery cabinet(s), PDM, an input cabinet (transformer or filter) and an output
transformer cabinet
Battery Input Cabinet
Cabinet (Transformer
or Filter)
(optional)
9315 uninterruptible power supply
®
Output PDM Cabinet
Transformer (optional–
(optional) requires
480/208 transformer)
1−1