Error! Style not defined. Error! Style not defined.
2. Remove the HDD pack by pulling on the tab attached to the pack.
NOTE: Do not disassemble the HDD pack when it is working normally. Disassemble or
replace the HDD pack only if it fails.
3. Place the HDD pack on a flat surface such as a desk.
4. To separate the plate from the HDD, remove four M3x3 screws according to the number
sequence sealed on the HDD plate.
2
CAUTION: Do not apply pressure to the top or bottom of the drive.
Satellite L450/Pro L450/L450D/Pro L450D Maintenance Manual
1
M3×3*4
Figure 4.3 Removing the HDD plate
4 Replacement Procedures
4
3
4-11