Installing The Odd Bay Module; Disassembling The Odd Drive - Toshiba Satellite Maintenance Manual

4 Replacement Procedures

Installing the ODD Bay Module

Install the ODD bay module according to the following procedures.
1. Place the ODD bay module in the correct position and slide it in.
2. Push it in until it meets the end.
3. Secure the ODD bay module with one M2.5x3 screw.

Disassembling the ODD Drive

NOTE: Do not disassemble the ODD drive when it is working normally. Disassemble or
replace the ODD drive only if it fails.
Disassemble the ODD drive according to the following procedures and Figure 4.9.
1. Remove two M2×2.5 screws.
2. Remove the bracket.
M2×2.5*2
Satellite L450/Pro L450/L450D/Pro L450D Maintenance Manual
Figure 4.9 Removing the bracket from the ODD drive
Error! Style not defined. Error! Style not defined.
4-18