Toshiba Satellite Pro T110DD Maintenance Manual page 189

Chapter 4 Replacement Procedures
Installing the touch pad
The following describes the procedure for installing the touch pad.
1. Peel off the separator covering on the sensor portion of a new touch pad.
NOTE: Do not reuse the touch pad so that it can not be used after peeling off from the
computer. Be sure to stick a new touch pad.
When sticking the touch pad, be careful not to get the bubbles under the touch
pad.
2. Stick and install the touch pad on the top cover assembly.
3. Connect the touch pad FFC to the connector on the touch pad.
4. Install the touch pad plate and the touch pad board, secure it with the following
screws.
 M2.0x2F FLAT BIND screw
5. Connect the touch pad FFC and the touch pad board FFC to the connector on the
touch pad board.
Satellite T110D / Satellite Pro T110D / PORTEGE T110D Maintenance Manual (960-Q08)
x8
37