Service And Maintenance; Accessories - Festool C 12 Li Instruction Manual

WARNING
Any maintenance or repair work that
requires opening of the motor or gear
housing should only be carried out by
an authorised Customer Service Centre
(name supplied by your dealer)!
Maintenance or repair work carried out by
an unauthorised person can lead to the
wrong connection of the power leads or
other components, which in turn can lead
to accidents with serious consequences.
Observe the following instructions:
– Keep the air slits on the machine and the
charger free and clean to ensure adequate
cooling.
– Keep the contacts on the machine, charger
and battery pack clean.
Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The accessory and tool order number can be
found in yout festool catalog or on the Inter-
net at „www.festool-usa.com".
Systainer
Many Festool products are shipped in a
unique system container, called "Systainer".
14

Service and maintenance

Accessories

Information on battery packs
– Where possible, store the battery pack in a
cool, dry place at a temperature between
5 °C and 25 °C.
– Battery packs are most efficient at temper-
atures between 20 °C and 30 °C.
– Protect the battery pack from moisture,
water and heat.
– Significantly shorter operating times after
each charge indicate that the battery pack
is worn and should be replaced with a new
one.
– The LiIon battery pack is fully compatible
with the charger! Integrated electronics
prevent overloading and overheating dur-
ing the charging process.
– Do not leave flat battery packs in a charger
disconnected from the mains power supply
for longer than one month. There is a risk
of total discharge and the maximum power
of the battery pack may decrease.
– Store the battery pack in its packaging to
reduce the risk of short circuits..
– If LiIon battery packs are to be stored for
long periods without use, they should be
charged to 40 %
15 mins. charging period).
This provides protection and storage for the
tool and accessories. The Systainers are
stackable and can be interlocked together.
They also can be interlocked atop Festool CT
dust extractors.
Place one systainer on top of the other.
Release all four latches on the lower sys-
tainer by pulling back at their top edges
[10-1].
capacity (approx.
10-3
10-2
10-1