Service And Maintenance - Festool DWC 18-2500 Operating Manual

DWC
GB
During reassembly of the transport lever into
the slides, pay due care to correct fitting of
the spring [13-3] in the transport lever. In-
correct assembly may result in dysfunction
of the belt transport.
10.2 Acoustic warning signals
Acoustic warning signal sounds and the machine
switches off to indicate the following operating
states:
Battery low or machine over-
loaded.
– Change the battery.
– Reduce machine workload.
Machine is overheating.
– You must allow the machine to
cool down before further usage.
Battery pack faulty or overheated.
– Once the battery pack has cooled
down, perform a function check
using the charger.
11

Service and maintenance

WARNING
Risk of injury, electric shock

Always disconnect the battery pack from the
machine before any cleaning or maintenance!

All maintenance and repair work which requires
the motor housing to be opened, must only be
carried out by an authorised service workshop.
16
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
EKAT
Only use original Festool spare parts!
4
Order No. at:
5
3
2
1
Note the following information:
– Keep the ventilation slits on the machine free and
clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
For service, maintenance, disposal and
transport of the battery pack, note enclosed
instructions of the battery pack!
12 Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh: