Dialling Mode (Tone/Pulse) Setting; Using The Telephone; Making A Call; Making A Call - Hands Free - Geemarc CL210A Instructions Manual

Telephone & answering machine

Hide thumbs Also See for CL210A:

Table of Contents

Enlarged version

SETTINGS

Dialling Mode (Tone/Pulse) Setting

The Tone/Pulse switch is factory pre-set to Tone position (T). In the UK,

all telephone exchanges now use Tone dialing. If your telephone does not

dial out, it is probably being used from an older private switch- board

(PBX). In this case, the Tone/Pulse switch (at rear of the unit) must be

moved to Pulse.

Pick up the handset.

When you hear the dialling tone, dial the number on the keypad.

To end the call simply replace the handset in the cradle

Making a Call – Hands Free

Press

. The hands free function will be activated,

Dial the required telephone number. To adjust the volume, use the

volume control VOL located on the right side of the telephone

When the third party answers the call, you may speak with the

telephone in the hands free mode ( handset in the cradle). Speak

towards the microphone located on the front edge of the telephone.

To end the call, press

Note: To deactivate the Hands Free function during a call, lift the handset.

To activate the Hands Free function during the call, press

replace the handset on the cradle at the same time.

Also, when in hands free mode, only one person may talk at a time. The

switch-over between speaker and microphone is automatic. This is

dependent on the sound level of the incoming call and the microphone

respectively. It is therefore essential that there are no loud noises, e.g.

music, in the immediate vicinity of the telephone, as this will disrupt the

hands free function.

and

Table of Contents