Telefunken TX100 User Manual page 82

Wait for approximately 15 seconds, and then plug it back in. Repeat the above suggestions
Phone does not work
- Have you installed the battery pack correctly?
- Check that the mains power is correctly connected.
No dial tone
- Is the telephone cord of the base plugged into the phone socket?
- Check that the mains power is switched on at the power point.
- Only use the telephone cord supplied with the phone.
- The telephone line cord might be malfunctioning. Install a new telephone line cord.
- Move the handset closer to the telephone base. It might be out of range.
- Disconnect the telephone base from the telephone wall socket and connect a different
telephone. If there is no dial tone on this telephone either, the problem is in your wiring or local
service. Contact your local telephone company.
Cannot dial out or receive calls
- Check that the mains power is correctly connected.
- The battery may need recharging.
- Has there been a power cut? If so, place the handset back on the base for 10 seconds and try
again. If it still does not work disconnect the battery pack and mains power for 10 minutes, then
reconnect and try again.
You have a dial tone, but the phone will not dial out
- If you are connected to a PABX, check whether you need to dial an access code.
Handset does not ring
- The ringer volume may be switched off..
- Check that the mains power is correctly connected.
- Make sure the handset is registered to the base.
No display
- The battery pack may be flat, dead or incorrectly inserted.
- Recharge or replace the battery pack
Battery icon does not appear to be filling
- Try cleaning the charging contacts.
- Check that the mains power is correctly connected.
- If the above measures do not correct the problem, replace the battery pack.
You hear the busy tone when you press HOME
- Make sure the handset is in range of the base.
- Another handset registered to your TELEFUNKEN TX 1** base may be on the line.
Answering machine does not record any messages
- Make sure the answering machine is switched on.
- The memory may be full, please delete some old messages to free up space.
- Make sure answering machine is set to ANSWER & RECORD mode.
TX Bluetooth 82