Table of Contents
Advertisement
YMF744B
2C-2Dh: Subsystem Vendor ID
Read Only
Default: 1073h
Access Bus Width: 8, 16, 32-bit
b15
b14
b13
b[15:0] ........Subsystem Vendor ID
This register contains the Subsystem Vendor ID. In general, this ID is used to distinguish adapters or
systems made by different IHVs using the same chip by the same vendor. This register is read only. To
write the IHV's Vendor ID, use 44-45h (Subsystem Vendor ID Write Register). IHVs must change this
ID to their Vendor ID in the BIOS POST routine.
In case of the system such as Sound Card which BIOS can not control, this ID can be changed by
connecting EEPROM externally. Then, Subsystem Vendor ID Write Register is invalid.
In case EEPROM is not externally, the default value is the YAMAHA's Vendor ID, 1073h.
2E-2Fh: Subsystem ID
Read Only
Default: 0010h
Access Bus Width: 8, 16, 32-bit
b15
b14
b13
b[15:0] ........Subsystem ID
This register contains the Subsystem ID. In general, this ID is used to distinguish adapters or systems
made by different IHVs using the same chip by the same vendor. This register is read only. To write
the IHV's Device ID, use 46-47h (Subsystem ID Write Register). IHVs must change this ID to their ID
in the BIOS POST routine.
In case of the system such as Sound Card which BIOS can not control, this ID can be changed by
connecting EEPROM externally. Then, Subsystem ID Write Register is invalid.
In case EEPROM is not externally, the default value is the YAMAHA's Device ID, 0010h.
b12
b11
b10
b9
Subsystem Vendor ID
b12
b11
b10
b9
b8
b7
b6
b5
b8
b7
b6
b5
Subsystem ID
-16-
b4
b3
b2
b1
b4
b3
b2
b1
February 3, 1999
b0
b0
Advertisement
Table of Contents
