Precor 9.45 Service Manual page 52

Procedure 6.10 - Replacing the Target Label (2P & 3Y Units)
WARNING
Always turn off the circuit breaker and unplug the treadmill before you remove the treadmill hood.
Removing the Target Label
1. Remove the hood.
CAUTION
The speed sensor is mounted on the motor casing. Exercise caution when you remove and
replace the flywheel.
2. Remove the flywheel as described in Procedure 5.17 of the Residential Treadmill Service
Manual.
3. Remove the target from the flywheel. Remove as much of the old adhesive as possible from
the flywheel. Ensure that any remaining adhesive is firmly bonded to the mounting location.
4. Clean the end of the flywheel with a mild detergent. Remove the detergent with a damp
cloth.
Replacing the Target Label
5. Remove the protective label from the adhesive side of the target label. Carefully position the
target on the flywheel, then press the target firmly.
6. Replace the flywheel as described in Procedure 5.17 of the Residential Treadmill Service
Manual.
7. Check the operation of the treadmill as described in Section Three of this appendix, then
replace the hood.
9.45, 9.45i Treadmill
Page 52