Procedure 4.2 - Calibrating The Lift Motor, 9.45 (2P Or 3Y) - Precor 9.45 Service Manual

Procedure 4.2 - Calibrating the Lift Motor, 9.45 (2P or 3Y)

1. Turn off the treadmill with the circuit breaker, then unplug the treadmill from the wall outlet.
2. Remove the hood.
3. Place the treadmill on its right side. Remove the bolt and nut that secure the lift tube to the
lift platform.
4. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
Press and hold the STOP, SPEED
5.
or keys 4,5,1,7,6,5,7,6,1, sequentially until the lift calibration number is displayed on the
console.
CAUTION
While running the lift motor in the calibration mode it is possible to operate the lift motor beyond
the motor's normal limits. When you perform the next step, care must be taken not to jam the lift
tube against the motor frame.
Press the INCLINE
6.
Press and hold STOP to get back to the Enter Your Weight banner.
7.
8. Turn off the treadmill with the circuit breaker, then unplug the treadmill from the wall outlet.
9. Turn the lift tube clockwise, by hand, as far as possible. Then turn the lift tube 10 -1/2 turns
(1-1/2") counterclockwise.
10. Replace the screw and nut that secure the lift tube to the lift platform. Return the treadmill to
an upright position.
11. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
12. Check the calibration of the lift system by performing the following steps:
Press the INCLINE
a
b Use the INCLINE
13. Using the ruler, measure the distance between the floor and the top of the front and back
ends of the side rail. The distance between the floor and the top of the front end of the side
rail should be equal.
14. Re-install the hood.
, SPEED
or INCLINE
keys to set the lift calibration number to 19.
key until the electronic console displays twelve percent incline;
key to return the treadmill to zero percent incline.
and QUICK START keys, simultameously
9.45, 9.45i Treadmill
Page 21