Installing the Imaging Unit
The imaging unit contains four OPCs (Organic
Photo Conductors) and developers and an imaging
unit transfer roller, that form the image that is
developed and transferred to the media.
Attention
The OPCs are extremely sensitive to bright light, direct sunlight, and
touch. Always leave the imaging unit in its protective package until
you're ready to install it. Any exposure to light should be limited to less
than two minutes, or permanent damage could result.
1
Open the front cover (press button A), and remove any tape.
2
Open the imaging unit cover.
3
Remove the imaging unit from its
protective bag.
4
Holding the imaging unit horizontally, pull the tabs straight out and com-
pletely away from the unit.
12
Setting up Your Printer