Renault Formula 1.6 2013 User Manual page 32

Release 1.0 - 24/04/2013
- Clean and check the conditions of the bearing journal
Put the new bearing using a press (or heating the shaft to approx. 120°C)
-
making sure it is correctly seated in its housing
Install a new lip seal in the back housing.
-
Install the primary shaft and set up the primary line shims (see 7.5)
-
Barrel bearings
Remove the barrel (see 7.6)
-
- Remove the barrel bearing
using a press and taking care
not to damage it
Clean and check the condition
-
of the bearing journal
Install the new bearing using a
-
press and making sure it is well
positioned against the shoulder
Remove the back casing lip seal
-
Heat the back casing using a hot air gun to approximately 120°C
-
Position an extractor FACOM (ref. U.49AD5) on the primary shaft bearing
-
loosened in the back casing and extract it with a slide hammer
Clean and check the conditions of the bearing journal
-
Put the new bearing using a press making sure it is correctly seated in its
-
housing
Install the lip seal in the back housing after checking its condition
-
Reinstall the barrel (see 7.6)
-
Secondary shaft bearings
Remove the differential and
-
secondary shaft (see 7.8)
Remove the front plate
-
bolts)
Remove the back casing lip seal
-
Heat the back casing using a hot air
-
gun to approximately 120°C
- Extract the external ring from the
back casing by hitting the ring
through the oil way hole
Clean and check the condition of the
-
bearing journal
- Fit the new ring using a press and
(4)
the
(1) (11xM6
32
4
1