How To Use - Flymo Scirocco 2200 Original Instructions Manual

F
2
1
J
L
x 5-6
WARNING
The use of eye protection is recommended. The use of
ear protection is recommended. To prevent dust
irritation, the wearing of a face-mask is recommended.
Never point your product at bystanders.
• The product has 2 modes of operation.
• These can be selected by moving the mode indicator (N) to
adjust the nozzle position for blow or vacuum mode.
Using As A Blower
Blow Mode - The product will blow debris from patios,
paths, driveways, lawns, bushes, borders etc.
1. Select the blow position on the mode indicator (N1)
2. Point nozzle towards the ground.
3. To start squeeze the switch lever (P).
4. Stand back from debris to be cleared.
5. Point the tube towards the debris and slowly approach.
6. To stop release the switch lever.
G
1
K
M1

How to Use

H1
Attaching the Shoulder Harness
1. Attach the Shoulder Harness to the product as
illustrated in Fig H1 or H2.
2. Adjust the Shoulder Harness as required to
ensure it is in the most comfortable position and
the collection tube is positioned slightly above the
debris. (J).
Securing the Access Screw
1, Remove the label from over the Access Screw (K).
2. Turn the Access Screw 5-6 times clockwise (L)
until tight (do not overtighten)
• Important:- Your product will not operate if
the Access Screw is not tightened.
Cable Restraint
1. Form loop in mains cable and push the loop
through the slot (M1).
2. To secure, position loop over the hook and
pull the cable back through the slot (M2).
M2
• If Blow performance is reduced, the tube may be
blocked. Open the Blockage Clearing Cap (Q1) and
clear the Blockage with blunt edge implement (Q2)
Using As A Vacuum
Vacuum Mode - In this position your product will pick
up leaves, small twigs and garden debris.
1. Select the vacuum position on the mode indicator. (N2).
2. Position the tube slightly above the debris, squeeze
the switch lever (P) and move the product slowly back
and forth.
3. Do not force the tube into the debris as this will impair
performance.
4. To stop release the switch lever.
H2