Assembly Instructions - Flymo Scirocco 2200 Original Instructions Manual

Flymo original instructions electric leaf collector
Table of Contents

Advertisement

A1
B1
C
E1
E3

Assembly Instructions

A2
B2
x 1.5 =
D
1
2
E2
E4
Blockage Clearing Cap (A1) & (A2)
1. Close the Blockage Clearing Cap ensuring it is
secure.
Suction Tube Assembly
1. Extend the lower suction tube to its full length. (B1)
2. Turn the lower suction tube anti-clockwise in the
direction of the arrow, approximately 1.5 times,
until it locks into position (B2)
IMPORTANT
When the Suction Tube is locked into the
operating position, this is a permanent fixture.
The Suction tube cannot be pushed back to its
packaged position.
Debris Outlet Assembly
1. Fit the Debris Outlet to the underside of the product
as illustrated in Fig C, until it locks into position.
Steady Handle Assembly (D)
1. Depress the two buttons on the sides of the
switch handle.
2. Locate the steady handle over the buttons and
release the buttons.
3. Adjust the steady handle to the most
comfortable operating position by depressing
the buttons and moving the handle.
Debris Bag Assembly
1. Slide the Tie Wrap into the top hem of the
Debris bag (E1)
2. Thread the Tie wrap completely round the hem
and locate the two ends of the Tie wrap
together (E2)
Important:- Do not tighten the Tie Wrap before
attaching the Debris Bag to the Debris Bag
Frame. If mistakenly done so, use a pointed
tool to loosen the Tie Wrap clip.
3. Attach the Debris Bag to the Debris Bag Frame
as illustrated in Fig E3, ensuring that the Tie
Wrap ends are at the opposite end to the
Debris Bag Frame handle.
4. Once the Debris Bag is located onto the Debris
Bag Frame, pull the Tie Wrap until the Debris
Bag is secure (E4). The excess end of the Tie
Wrap can either be removed or tucked into the
top hem.
Attaching Debris Bag to product
1. Locate bag frame into clip on the underside of
product. (F1).
2. Lift handle towards product until bag latch
locates and click into place. (F2)
Removing Debris Bag from Product
1. Gently press bag latch (G1) down.
2. Lower handle of bag frame away from product.
3. Move bag frame forward.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scirocco 2500Scirocco 3000

Table of Contents