Web Configuration
Default Gateway
Choose ADVANCED > Routing and click Default Gateway. The page as shown in the
figure appears.
In this page, you can select Enable Automatic Assigned Default Gateway, or enter the
information in the Use Gateway IP Address and Use Interface fields. Click Apply to save
the settings.
RIP
Choose ADVANCED > Routing and click RIP. The page shown in the following figure
appears. This page is used to select the interfaces on your device that use RIP and the
version of the protocol used.
If you are using this device as a RIP-enabled device to communicate with others using
the routing information protocol, enable RIP and click Apply to save the settings.
D-Link DSL-2640BT User Manual
66