Default Gateway; Rip - D-Link DSL-2642B User Manual

Section 3 – Configuration
To access Default Gateway, point to the Routing on the left window and click Default Gateway submenu, or click the Default Gateway button in
the Routing window.
This page can either automatically assign a default gateway to the
device or manually type in a default gateway or the device or interface. It
is recommended to select Enable Automatic Assigned Default
Gateway to automatically detect the Gateway IP address.
To access RIP, point to the Routing on the left window and click RIP submenu, or click the RIP button in the Routing window.
The Router supports RIP version 1 and 2 used to share routing tables
with other Layer 3 routing devices on your local network or remote LAN.
The Operation setting refers to the RIP request. Select Active to allow
RIP requests from other devices. Select Passive to instruct the Router to
make RIP requests for routing tables from other devices.
To enable RIP, tick the Enable check box of the interface you want to
enable, select the Version (1, 2, or Both) and Operation (Active or
Passive), and tick the Enable check box in the corresponding entry. Click
the Apply/Save button to let your changes take effect.
D-Link DSL-2642B User Manual

Default Gateway

RIP

88