Table of Contents
Advertisement
Menu system
>>> Output handling
• Select the profile for which you wish to configure the output
handling.
• Select the number of the output relays to be activated when an
enabled event in the selected profile is activated.
• Enable the beeper to activate it when an enabled event in the
selected profile is activated.
>>> Recording setup
• Recording behavior for each of the six profiles is specified in three
submenus. The
Normal
alarms or motion events. The
The
submenu is for motion events.
Motion
• The list gives an overview of inputs and motions that are used in any
of the profiles. A check mark means used.
Normal
• Select the profile. The
Unallocated IPS
capacity remaining.
• A total of 60 images per second (IPS) can be recorded for NTSC; 50
IPS for PAL. A minimum of 1 IPS is always allocated per camera for
pre-alarm recording and network viewing.
• Set the recording rates and quality levels for each camera. Quality is
standard, medium or high.
• IPS rates for PAL range from Never, 0, 1/10 (one image every 10
seconds), up to 25 IPS.
• IPS rates for NTSC range from Never, 0, 1/10 (one image every 10
seconds), up to 30 IPS.
• Set the recording speed to NEVER to not record a camera at all. No
pre-alarm recording is done and the camera cannot be viewed over
the network.
5-14
submenu is for a normal situation without
submenu is for input changes.
Input
item shows the IPS
Input
• Each input, when activated, can change the normal recording
behavior of up to four cameras for a maximum of 120 seconds.
• Select the profile. Select the input number.
• Select the cameras whose recording behavior should change. Set the
recording rates and quality levels for each camera. Set camera name
to
to use less than four cameras.
None
• To free IPS bandwidth, the recording rate of cameras not in alarm is
limited to the IPS number displayed.
Motion
• Each motion input, when activated, can change the normal
recording behavior of up to four cameras for a maximum of 120
seconds.
• Select the profile. Select the motion camera number.
• Select the cameras whose recording behavior should change. Set the
recording rates and quality levels for each camera. Set camera name
to
to use less than four cameras.
None
• To free IPS bandwidth, the recording rate of cameras not in alarm is
limited to the IPS number displayed.
>>> Access restrictions
• Remote access restrictions can be set for each of the six profiles.
Remote user 1, the administrator, always has access.
• Select the profile. Select if remote playback can be enabled or not
for remote users.
• Select which remote users have access and which are blocked.
>>> Copy system behavior
• To copy the settings of one profile to another, enter the number of
the source profile, enter the number of the destination profile and
select the
item.
Copy Now
Philips Communication, Security & Imaging
Advertisement
Table of Contents
