Table of Contents
Advertisement
>> Local Passwords
• Set or change the password that allows access to playback functions.
• Set or change the password that allows access to the configuration
functions.
• Use the camera keys (1 to 9) on the front of the unit to enter a four-digit
password in the dialog box that appears.
• Enter the same password again to have it verified.
• Press F2 to remove password protection.
>> Connectivity
The
menu gives access to settings that control the behavior of the
Connectivity
unit with respect to all external devices or a network. It also gives access to
settings for connecting multiple units to each other and for connecting
computers via the communications port.
>>> Keyboard access restrictions
• Four external keyboards can be connected to the unit.
• Allow these keyboards to control monitor A only, monitor B only,
both or neither.
>>> Network setup
• Set DHCP to
to have IP address, subnet mask and default
Yes
gateway assigned automatically by the network server. The actual
values are displayed.
• Enter a Divar name to be used in the network.
• Fill in the IP, subnet mask and default gateway addresses when
DHCP is set to
. The MAC address is read only.
No
• Restrict the network bandwidth by entering an Mbps between 0 and
100 for the bandwidth limit.
Philips Communication, Security & Imaging
>>> Network access
• Access to the unit via the network can be set for up to six different
users.
• Restrict access to the unit by listing an IP address range. The range
you use will normally depend on your network setup.
• Select a user number to set up the configuration for that remote
user. The administrator is user 1 and is identified as
ADMINISTRATOR.
IP Range
• Eight IP ranges can be entered to allow access.
• Enter the same begin and end address to specify a single IP address.
Enter different begin and end addresses to specify an IP address
range.
• Use the up/down arrow keys to move to an IP entry. Press the select
key to edit the entries. Press F1 to set the default values
(000.000.000.000 to 255.255.255.255).
List of Users
• Enter a name, up to 16-characters long, for each user. Enter a
password up to 12-digits long.
• Set
to
to restrict viewing rights to live video only.
User Rights
Live
• Select the cameras in the
Camera Lock Out
accessible for the user.
• Set the camera sequence list and dwell time (from 3 to 59 seconds)
for the remote viewer. All connected cameras are listed by default.
• Set
to allow control of controllable cameras
Camera Control
remotely.
Menu system
submenu that are not
5-11
Advertisement
Table of Contents
