Baumatic BL18A Instruction Manual page 21

o Secure the bottom of the furniture door to the appliance door,
using the two fixing brackets, tightening screws into the two
holes that you made in step 10.
o If the bracket isn't flush, then you should raise the level of the
appliance, using the levelling feet (See the "Adjusting the height
and levelling off your fridge" page).
o Use a suitably sized drill bit to drill through the three holes in the
bracket, into the work top. IMPORTANT: The drill bit should be
appropriate for the material that your work top is made from.
o Secure the bracket to the underside of the worktop, using the
screws provided. IMPORTANT: These screws should be fully
tightened.
Check that the door opens and shuts without snagging, as
well as checking that the door is sealing correctly.
11) Rehang the furniture
door and make the same
adjustments that you made
in step 9.
o Tighten the retaining
nuts at the top of the
appliance door.
12) The bracket at the top
of the fridge door should b
flush with the underside of
the work top.
13) Open the appliance
door.
e
21