Positioning; Aperture Dimensions - Baumatic BL18A Instruction Manual

Positioning

o It is advisable that your appliance is only installed in a location
where the ambient temperature of the room, corresponds with
the climate classification that is stated on the rating plate of your
appliance. Your appliance may not function correctly if the
ambient temperature falls outside of the following ranges.
Climate classification Appropriate ambient temperature
SN
N
o Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler).
o The door should be able to open completely and freely
o The appliance should be situated so you can easily access the
food that is stored in it.
o You should check whether there is an electrical socket available,
which will be accessible after your appliance is installed.
o IMPORTANT: To allow the door of the appliance to open without
fouling the unit that is next to it. It maybe necessary to insert an
18 – 20 mm cabinet side/end panel between the appliance and
the base unit. It should be positioned on the same side that the
appliance door is hinged on.

Aperture dimensions

o The appliance must be stood on a level floor. You can use the
levelling feet to take into account any minor unevenness in
the floor.
+10 to +32 degrees centigrade
+16 to +32 degrees centigrade
1) Figure 1 shows the aperture size
that you will need to be able to install
your appliance.
16