Pressure Regulation And Testing - Blodgett XR8-G Installation Operation & Maintenance

PRESSURE REGULaTIOn and TESTInG

XR8-G ovens are rated at 110,000 BTU/Hr. (32 kW) (116
MJ/hr). Each oven has been adjusted at the factory to
operate with the type of gas specified on the rating plate.
InLET PRESSURE
natural
Min
W.C. 6.0
kPa 1.2
ManIFOLd PRESSURE
natural
W.C. 3.5
kPa
.87
• Inlet Pressure - the pressure of the gas before it
reaches the oven.
• Manifold Pressure - the pressure of the gas as it
enters the main burner(s).
• Min - the minimum pressure recommended to oper-
ate the oven.
• Max - the maximum pressure at which the manufac-
turer warrants the oven's operation.
Propane
Max Min
14.0 11.0
3.5 2.7
Propane
10.0
2.5
Gas Connection
2.78" (71 mm)
Each oven is supplied with a regulator to maintain the
proper gas pressure. The regulator is essential to the
proper operation of the oven and should not be removed.
It is preset to provide the oven with 3.5" W.C. (.87 kPa)
for natural gas and 10.0" W.C. (2.5 kPa) for Propane at
the manifold.
DO NOT INSTALL AN ADDITIONAL REGULATOR
Max
WHERE THE OVEN CONNECTS TO THE GAS SUPPLY
UNLESS THE INLET PRESSURE IS ABOVE MAXIMUM.
14.0
3.5
Prior to connecting the oven, gas lines should be thor-
oughly purged of all metal filings, shavings, pipe dope,
and other debris. After connection, the oven should be
checked for correct gas pressure.
The oven and its individual shutoff valve must be discon-
nected from the gas supply piping system during any
pressure testing of that system at test pressures in ex-
cess of 1/2 psig (3.45kPa).
The oven must be isolated from the gas supply piping
system by closing its individual manual shutoff valve dur-
ing any pressure testing of the gas piping system at test
pressures equal or less than 1/2 psig (3.45kPa).
Figure 4
9
Installation
Gas Connection (XR8-G only)
Side View with Stand
Gas Connection
37.83" (961 mm)