Setting Up Your Scanner; Installing And Replacing Batteries - Uniden EZI30XLT Owner's Manual

SETTING UP YOUR SCANNER

These guidelines will help you install and use your new scanner:
• If your scanner receives interference or electrical noise, move
the scanner or its antenna away from the source.
• To improve the scanner's reception, use an optional external
antenna designed for multiband coverage. (You can purchase
this type of antenna at a local electronics store). If the
optional antenna has no cable, use 50 ohm coaxial cable
for lead-in. A mating plug might be necessary for the optional
antennas.
• Do not use the scanner in high-moisture environments such
as the kitchen or bathroom.
• Avoid placing the scanner in direct sunlight or near heating
elements or vents.

Installing and Replacing Batteries

You can power your scanner using three AA alkaline batteries.
1. Make sure the power is turned off.
2. If the belt clip is attached, remove it (See page 12).
3. Slide the battery compartment cover.
UNIDEN EZI30XLT
9
Scanner