GE JKP90– 27 Owner's Manual page 37

WARNING
CAUTION
Receptacle
Socket
G6.35 Bulb
Tab
Glass cover
Socket
Receptacle
G9 Bulb
Tab
Glass cover
Socket
3 "
1 2
Maximum
length
Bulb
Tab
Glass cover
in electric shock or burn.
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot
glass with bare hands or a damp cloth can cause burns.
Oven Light Replacement
To remove:
Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear
the grooves of the socket. Wearing latex
gloves may offer a better grip.
Using gloves or a dry cloth, remove the
bulb by pulling it straight out.
To replace:
Use a new 120/130-volt halogen bulb, not
to exceed 50 watts. Replace the bulb with
the same type of bulb that was removed.
Your model will have one of the two types
shown on the left. To determine the
correct replacement bulb, check the bulb
terminals. Bulbs with 2 straight pin
terminals are G6.35 bulbs. Bulbs with 2
looped terminals are G9 bulbs. (Do not
interchange.) Be sure the replacement
bulb is rated 120 volts or 130 volts (NOT 12
volts).
Using gloves or a dry cloth, remove the
bulb from its packaging. Do not touch the
bulb with bare fingers. Oil from skin will
damage the bulb and shorten its life.
Lower Oven Light Bulb
To remove:
Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear the
grooves of the socket. Remove the bulb.
To replace:
Put in a new 40-watt appliance bulb. Place the
tabs of the glass cover into the grooves of the
socket. Turn the glass cover clockwise 1/4 turn.
Receptacle
Push the bulb straight into the receptacle
all the way.
Place the tabs of the glass cover into the
grooves of the socket. Turn the glass cover
clockwise 1/4 turn.
For improved lighting inside the oven,
clean the glass cover frequently using a
wet cloth. This should be done when the
oven is completely cool.
Reconnect electrical power to the oven.
NOTES:
A 40-watt appliance bulb is smaller than
a standard 40-watt household bulb.
Install and tighten the cover clockwise.
Reconnect electrical power to the oven.
For improved lighting inside the oven, clean
the glass cover frequently using a wet
cloth. This should be done when the oven is
completely cool.
GEAppliances.com
Use
gloves or
cloth
37