Fisher-Price POWER WHEELS 75598 Assembly And Owner's Manual page 20

33
PUSH
HERE
Side
Fender
PULL UP HERE
• Fit the sport bar and sport bar support legs into the holes
in the vehicle body.
• Push down firmly on a sport bar side leg while pulling
up on the side fender to fit the sport bar into the
vehicle body.
• Repeat this procedure on the other side of the
vehicle body.
34
Sport Bar
Rear
Wheel Well
1 1 / " x 1 / " Screw
2 4
• Insert a 1 1 / " x 1 / " machine screw into the hole closest to
2 4
the front of the vehicle in the underside of the rear wheel
well, through the vehicle body and into the end of the
sport bar. Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure on the other side of the
vehicle body.
IMPORTANT! Make sure to assemble the two 1
machine screws to hold the sport bar and the sport bar
supports in place.
Assembly
Sport Bar
Side Legs
1 / " x 1 / "
2 4
20
35
Rear Bumper
Tabs
Lower Rail
• Face the rear of the vehicle.
• Fit the lower rail on the rear bumper over the rear
bumper supports.
• Gently bend the tabs at the bottom of the rear bumper
under the vehicle.
36
Taillight
Lens
Rear Bumper Light Plate
Taillight Housing
• Using safety scissors, remove the taillight lenses and the
taillight housings from the plastic connectors. Dispose of
the plastic connectors.
• Face the rear of the vehicle.
• Fit a taillight lens inside a taillight housing.
• Position the taillight housing with lens against a rear
bumper light plate with the screw holes aligned.
• Insert two #8 x 1" screws through the taillight lens, rear
bumper light plate housing and into the vehicle body.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure to attach the other taillight.
Rear Bumper
Support