Fisher-Price POWER WHEELS 75598 Assembly And Owner's Manual page 12

2
Battery
Clamp Unit
• Insert two #10 x 1" screws through the holes in the
battery clamp unit and into the pegs in the dash.
• Tighten the screws with a Phillips screwdriver.
Do not over tighten.
3
2
1
Battery Clamp
1
• Position the dash on the vehicle body.
• Make sure the motor harness connector wire is through
the groove in the dash.
• Insert a #10 x 1 / " screw through each of the two corner
2
dash tabs nearest to the passenger compartment
• Insert a #10 x 1" screw through the two dash tabs
nearest to the battery compartment
• Insert a #10 x 1" screw into the hole in the center of the
dash, near the battery clamp
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Assembly
2
2
1
Dash
Motor
Harness
Connector
Wire
Battery
Compartment
2
.
.
4
Left Sidepipe
• Turn the vehicle body upside down.
• Fit the left sidepipe under the left (driver) side of the
vehicle body.
• Insert two #8 x
sidepipe and into the screw pegs on the underside of
the vehicle body.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to assemble the right sidepipe to
the right side of the vehicle body.
5
• Turn the vehicle body upright.
• Gently bend the tab on one of the sidepipes under the
vehicle body.
.
• Insert a #8 x
body floor and into the tab.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to fasten the other sidepipe on the
other side of the vehicle body.
12
Rear of Vehicle
Vehicle Body
Screw Pegs
3 screws through the top of the left
/ "
4
Rear of Vehicle
Tab
3 screw through the hole in the vehicle
/ "
4