Fisher-Price POWER WHEELS 75598 Assembly And Owner's Manual page 17

21
Windshield Frame – Back
Slots
Windshield Frame –
Front
• Fit the back windshield frame onto the front windshield
frame. Make sure the slots at the bottom of the two
windshield frames are aligned.
• Insert ten #8 x 1 1 / " screws into the back windshield frame.
4
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Hint: Squeeze the two windshield frames together while
tightening the screws.
• Lift the assembled windshield to the raised position.
22
Tabs
Slot
• Position the hood over the front of the vehicle body.
• Insert the tabs on the hood into the slots in the
vehicle body.
• Close the hood
Assembly
Slots
Hood
Slot
17
23
Short Seat
Belt Strap
End
T-Loops
Seat
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap through
the slot near the outer edge of the seat. Make sure the
side of the seat belt with the fastener faces the outer
edge of the seat.
• Pull the short seat belt strap completely through the
slot until the last T-loop at the opposite end of the belt
catches against the slot. You will pull one T-loop through
the slot.
• Repeat this procedure to assemble the other short seat
belt strap.
24
T-Loop
Fastener
• Insert each end of the long seat belt strap through a slot
in the center of the seat. Make sure the fasteners face the
outer edge of the seat.
• Pull each side of the long seat belt strap evenly through
the slots. Make sure to pull each T-loop through a slot.
• Turn the seat upright.
T-Loop (pull through slot)
Fastener End
Slot
Long Seat Belt Strap
Slot