Installation Of Ca2 Board - Epson PhotoPC 850Z Service Manual

EPSON PhotoPC 850Z

4.3.4 Installation of CA2 Board

1. Install the Lens Assy. (see 4.3.1 "Assembly of Lens Assy.").
2. Connect the FPC (1) to Connectors CN101 of the CA1 Board and CN901
of the CA2 Board (2) (see Figure 4-11).
3. Fix the CA2 Board on the Holder Chassis with 2 screws (17x4.0) (3).
(Tightening torque: 1.0 ~ 1.4kgf-cm)
NOTE: Secure the CA2 Board on the Holder Chassis with a fixing hook
without fail.
4. Insert the FPC of the Lens Assy. into CN952 of the CA2 Board.
5. Insert the FPC of the Lens Assy. into CN951 of the CA2 Board.
NOTE: Arrange the FPC as shown in the following figure.
Figure 4-10. Arrangement of FPC
Disassembly and Assembly
Note:
Be careful not to
damage the FPC with
Connector, Pin.
Push the FPC
inside.
Assembly Procedure
VF Harness
To CN101
FPC of the Lens Assy.
To CN901 of CA1
Press down both
edges of the lock
cover to fix CN101.
Figure 4-11. Installation of CA2 Board
Revision A
Fixing Hook for CA2
73