Ten-Tec SSB-CW-AM Instruction Manual page 8

4. Check and organize ALL Main Board parts per the Kit parts
List before you start soldering. Electronics hobbyists have many
different ways of sorting and organizing small parts: standing them
on a block of styrofoam or in the holes along the edge of
corrugated cardboard, arranging them in an egg carton or muffin
tin, or making logical piles in a small tray.
5. This kit manual offers you the further opportunity to "PRE-
ORGANIZE" the parts exactly needed for each of the five Main
Board Assembly Phases 2.0 through 6.0. After the sectional board
drawings and schematics introducing each Assembly Phase, see
the Quick Reference List of parts (with circuit functions) used for
that phase.
There are a few VERY Small Parts . . .
The main goal, of course is to locate these and not to lose them!
HARDWARE ITEMS
Please refer as needed to the "Model 1254 Mechanical Details"
foldout page at the end of this section to see how all major parts and
sections of your receiver go together. Sizes and descriptions of
smaller hardware items such as screws are specified clearly in
instruction steps.
6. If you believe any parts are missing from your kit package,
the warranty explains how to contact us for replacement
parts.
7. We encourage you just to take your time with this project. Build it
for the sake of the building experience. You'll use the receiver for
years, but you'll only build it once. It really is worth your time to
learn about it as you build it!
ulators for Y1, Y3 (2)
1254 - Getting Started - 7