Ten-Tec SSB-CW-AM Instruction Manual page 23

Before you do ANY soldering,
we remind you again to do the following:
Check and organize your kit parts in whatever way
Is most convenient for you. A special IDENTIFICATION
GUIDE is provided after the Parts List.
Go through this entire manual: familiarize yourself
with its organization and illustrations.
Prepare a clean, well-lighted workspace.
Study the ASSEMBLY OVERVIEW
(Getting Started Section, Page 20)
Build the Display Board FIRST. All its parts are packed
with the board itself, and it is a good orientation project.
Installing Parts on the Circuit Boards:
When we say "INSTALL" a part, this is what we mean:
Choose correct part value
Insert in correct PC Board location
Insert correctly, if there is a right way and wrong way
such as for diodes, IC's,
electrolytic capacitors, transistors etc.
Insert the part as far as it can go into the board.
Solder all wires or pins
Trim or "nip" excess wire lengths
of a type intended for electronic PC-board assembly.
(Available at electronics distributors or Radio Shack" stores.)
DO NOT use hardware store solder, paste or flux,
Solder contains LEAD: wash hands before eating!
USE ROSIN.CORE SOLDER ONLY.
1254 Assembly - 2